Removing the Camera
1. Follow the procedures in Before Working Inside your computer.
2. Remove:
a. battery
b. display assembly
c. display bezel
3. Perform the following steps to remove the camera:
a. Disconnect the camera cable.
b. Remove the screw that secures the camera module.
c. Lift the camera module from the computer.
Installing the Camera
1. Place the camera module in its slot in the computer.
2. Tighten the screw to secure the camera to the display assembly.
3. Connect the camera cable.
4. Install:
a. display bezel
b. display assembly
c. battery
5. Follow the procedures in After Working Inside Your Computer.
55
To Next Page
Loading...
