Figure 102. System Setup Page
2. Enter the Storage Center management IPv4 address in the Management IP Address (IPv4) field.
3. If the management network uses IPv6, enter the Storage Center management IPv6 address in the
Management IP Address (IPv6) field.
4. Click Continue. The wizard prompts you to enable or disable the read and write cache.
Figure 103. Enable Read and Write Cache
5. Select or clear the checkboxes to enable or disable read and write cache.
NOTE: Disable cache only if there will never be volumes that use cache. If cache is left enabled
on this page, it can be disabled later for individual volumes. For more information, see the
Storage Center System Manager Administrator’s Guide.
6. Click Continue. The Configure SMTP page opens.
120
Set up Storage Center Software
To Next Page
Loading...
