Figure 144. Connect B Side Cables to the New Expansion Enclosure
1. Storage system 2. Storage controller 1
3. Storage controller 2 4. Expansion enclosure 1
5. New expansion enclosure (2)
Label the Back-End Cables
Label the back-end cables that interconnect the storage controllers or label the back-end cables that
connect the storage system to the expansion enclosures.
Prerequisites
Locate the cable labels provided with the expansion enclosures.
About this task
Apply cable labels to both ends of each SAS cable to indicate the chain number and side (A or B).
Steps
1. Starting with the top edge of the label, attach the label to the cable near the connector.
160
Adding or Removing an Expansion Enclosure
To Next Page
Loading...
