Figure 143. Disconnect the B-Side Cable from the Expansion Enclosure
1. Storage system 2. Storage controller 1
3. Storage controller 2 4. Expansion enclosure 1
5. New expansion enclosure (2)
2. Connect the B-side cable that was disconnected in the previous step to the new expansion
enclosure (2): right EMM, port C.
3. Use a new SAS cable to connect expansion enclosure 1: right EMM, port A to the new expansion
enclosure (2): right EMM, port B.
Adding or Removing an Expansion Enclosure
159
To Next Page
Loading...
