Figure 52. Attach Label to Cable
2. Wrap the label around the cable until it fully encircles the cable. The bottom of each label is clear so
that it does not obscure the text.
Figure 53. Wrap Label Around Cable
3. Apply a matching label to the other end of the cable.
Connecting to iSCSI Host Servers
Choose the iSCSI connectivity option that best suits the front‐end redundancy requirements and network
infrastructure.
Preparing Host Servers
Install the iSCSI host bus adapters (HBAs) or iSCSI network adapters, install the drivers, and make sure that
the latest supported firmware is installed.
• Contact your solution provider for a list of supported iSCSI HBAs.
• Refer to the Dell Storage Compatibility Matrix for a list of supported HBAs.
66
Connect the Front-End Cabling
To Next Page
Loading...
