Figure 101. Time Settings Page
NOTE: For locations in the United States, either select US as the region and select a time
zone name, or select America as the region and select a city within the same time zone.
2. Set the system time using one of the following methods.
• To configure time manually, select Configure Time Manually, then enter the date and time.
• To configure time using a Network Time Protocol (NTP) server, select Use NTP Time Server, then
enter the fully qualified domain name (FQDN) or IP address of an NTP server.
NOTE: Accurate time synchronization is critical for replications. Dell recommends using
NTP to set the system time. For more information, see: http://support.ntp.org/bin/view/
Support/WebHome.
3. When the system time has been set, click Continue. The System Setup page oepns.
System Setup Page
Use the System Setup page to specify the system name and management IP address for Storage Center.
About this task
Refer to the pre-installation documents to find the Storage Center management IP address.
Steps
1. In the System Name field, enter a name for the Storage Center. The system name is typically the
serial number of
storage controller 1.
Set up Storage Center Software
119
To Next Page
Loading...
