Figure 40. Securing a Drive in the Drawer
NOTE: It is possible for a drive to appear seated but not be fully locked into position,
eventually causing it to dislodge itself. After installing a drive, check the release button in the
center of the DDIC. If the drive is NOT fully locked into position, a yellow line will be visible
underneath the arrow button. If the yellow line is visible, remove the drive and re-install it.
CAUTION: If the DDIC fails to latch, do not use it and request a replacement from Dell
Technical Support. If a faulty DDIC unlatches within a closed drawer, you may not be able
to open the drawer.
3. Close the drawer after adding all of the DDICs.
a. Locate the two lock-release buttons situated midway along the runners on each side of the
drawer.
b. Press the lock-release buttons inward and use your body to push the drawer toward the chassis
until the locks disengage.
c. Place your hands on the front bezel and continue to push the drawer inward until the bezel is
flush with the chassis and the front drawer locks engage.
46
Install the Storage Center Hardware
To Next Page
Loading...
