YDT-35 Operating and Servicing Manual
HL066(EN) ISSUE 1, 05/2015 23
Figure 3.11 Mains Electrical Switch
11. On first injector test it will be necessary to run the injector for a minimum of 2 minutes to
ensure the hydraulic system is completely purged of air before diagnosing any injectors –
refer to Section 4 for injector setup and system operation information.
NOTE: the machine may produce a continuous beeping sound upon first start up. This can be
cleared by selecting the correct injector type from the main menu based on the injector fitted to the
machine.
12. Using the buttons on the Control Panel, navigate to Settings >> 5.Languages and select
your preferred language.
The machine is now fully installed and ready to use.
3.5 Powering down the machine
1. Stop any active test
2. Switch OFF the mains power switch on the rear of the machine.
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
To Next Page
Loading...
Need help?
General