DELTA DORE Tybox 137+ - Association with a Repeater; Factory Reset

10
9. Association with a repeater
If the radio signal is weak and the transmier cannot be moved closer to the receiver, you can add an X3D
repeater (booster) to your installation (example: ERX 2000).
10. Factory reset
The default factory seings may be restored for each of the menus.
2
1
4
3
7
... ... ...
OFF
> 3s
>5s
5
6
EXIT
❶ Press the ERX 2000 receiver
buon for 3 seconds until the red
LED ashes. Release.
❷ Turn the dial on the transmier
to
, then press the i buon for 5
seconds (❸).
❹ Briey press R.
The display shows rAd 1.
❺ Briey press
i.
❻ The “1” ashes then displays “2”.
The booster LED stops ashing.
❼ To exit the mode, turn the dial.
>5s >5s
OU
3
4
3
4
5
EXIT
Init
Menu 1
Init
Menu 2
1
2
❶ Turn the dial to , then press
the i buon for 5 seconds (❷).
❸ Press the buon on the menu
you wish to reset, and hold the
buon for 5 seconds.
❹ Then press the OK buon to
conrm the reset.
❺ To exit the mode, turn the dial.
OR
Reset
Menu 1
Reset
Menu 2