DELTA DORE Tybox 137+ - Unpairing;Re-associating Receiver; Removing Associations from Receiver; Radio Quality Test

11
11. Installation Assistance
11.1 Unpairing/re-associating the receiver with the transmier
If there’s a breakdown, you may need to unpair a product and/or re-associate a new one.
Unpairing the transmier from the receiver
Re-associating the receiver to the transmier
>5s >5s
EXIT
1
2
4
5
6
3
❶ Turn the dial on the transmier
to
, then press the i buon for 5
seconds (❷).
❸ Press the R buon for 5 seconds.
❹ Then press the OK buon to
conrm the reset.
❺ Press R to verify that rAd = 0.
❻ To exit the mode, turn the dial.
2
1
4
3
7
... ... ...
OFF
> 3s
>5s
5
6
EXIT
❶ Press the receiver buon for 3
seconds until the red LED ashes.
Release.
❷ Turn the dial on the transmier
to
, then press the i buon for 5
seconds (❸).
❹ Briey press R.
The display shows rAd 0.
❺ Briey press
i.
❻ The “0” ashes then displays “1”.
The receiver LED stops ashing.
❼ To exit the mode, turn the dial.
... ...
.. .. ..... ..
..
... ... ...
If the green light is ashing (in ashes), make sure it is ashing in a
sequence of single ashes. If it is not in the single ash sequence, your
receiver will not be able to associate with the transmier
Choose the number of ashes by successive presses on the buon:
1 ash -> Press -> 2 ashes -> Press -> 3 ashes -> Press -> 1 ash...