DELTA DORE Tybox 137+ - Override Function; Information Button Usage

15
3. Override
In AUTO mode, you can use the override to change the setpoint temperature until the next programmed point.
Programming
type
Override
type
Operating mode
Programming via the
Tybox
Comfort or
Economy
Example: it is 15:30 and you would like to switch to Comfort mode
before the set time (17:00).
6h 8h 0h0h 17h 23h
15h30
1
2
3
❶ Press
the buon
❷ Override
in progress
❸ At 17:00, the programme
will return to its usual
schedule.
To cancel the current override, press the buon once more.
Programming via the
Tydom app (menu 1-10 = 1)
Setpoint
temperature
adjustment.
1
2
3
4
❶ Press the
OK buon.
❷ Set the desired
setpoint using + and -
and conrm with OK
(❸).
❹ The override will be
cancelled the next time the
Tydom app programme
changes.
4. Information button
In AUTO, manual or o mode, successive presses on the i buon enable you to:
- nd out the room temperature or the setpoint temperature (depending on the conguration
during installation (menu 2-04),
- show the boiler/heat pump operating hours meter, as well as the number of days remaining
before maintenance (if this seing is on, menu 2-07),
- show any faults (see § "Changing baeries").
h(ON)
023
4
5
Operating hours meter (boiler/
heat pump).
Measured
temperature
Setpoint
temperature
Time to boiler/heat pump
maintenance
Return to automatic
mode