DELTA DORE Tybox 137+ - Removing Associations from the Receiver; Radio Quality Test

12
11.2 Removing associations from the receiver
Hold down the buon to remove the radio associations from the receiver.
: The red LED ashes aer 3 seconds.
The receiver is in pairing/association mode.
: If you continue holding down the buon, the red LED ashes quickly aer 10 seconds.
The receiver is waiting to remove the association with an opening detector or a booster (check on the device you
want to unpair).
: If you continue holding down the buon, the red LED turns o aer 20 seconds.
All associations with the receiver are now removed.
: If you continue holding down the buon for 30 seconds, the LED ashes 3 times.
The receiver is fully reset (back to factory seings).
11.3 Radio quality test
This mode helps you check the radio quality between the transmier and the receiver.
1
> 3s > 10s > 20s
A B C
> 30s
D
1
3
2
6
>5s >3s
4
5
EXIT
❶ Turn the dial on the transmier
to
, then press the i buon for 5
seconds (❷).
❸ Briey press R buon once.
The display shows rAd.
❹ Press OK for 3 seconds until the
display shows "tESt".
❺ The number shows the
transmission quality percentage
< 30 Weak
from 30 to 60 OK
> 60 Good
If the number is too low, move the
transmier closer to the receiver
or add a repeater (booster) to your
installation.
❻ To exit the mode, turn the dial.