Chapter 5 Main Circuit TerminalsC2000 Plus
5-5
Figure 5-7
Figure 5-8
NOTE:
1. Mark *1 means that refer to Section 7-1 for brake units and resistors selection.
2. If the wiring between motor drive and motor is over 75 meters, refer to Section 7-4 Specifications of
limits for motor cable length.
3. Frame G and H models use 12 pulse input, you should remove the short circuit plate (see the figure
below). Consult with Delta before using 12 pulse input.
4. When wiring for 12 pulse input, strictly follow above wiring diagram.
To Next Page
Loading...
