DVS Series Managed Industrial Ethernet Switches User’s Manual
3-102
Description Factory Default
Sample Type
Specify the sample type for the alarm, which defines how the variable is
sampled, and how the value is calculated and compared with the
thresholds that you configure. Make a selection from the drop-down
list:
Absolute Value: The value of the variable is compared directly with
the thresholds at the end of the sampling interval.
Delta Value: The value of the variable that was obtained at the last
sample is subtracted from the current value, and the difference is
compared with the thresholds.
None
Rising Threshold
Specify the rising threshold for the sampled statistic. If the configured
threshold value is reached, an alarm is raised. If the current sampled
value is greater than or equal to this threshold, and the value at the last
sampling interval was less than this threshold, a single event is
generated. Enter a value between 0 and 2147483647.
Note:
The rising threshold value needs to be greater than the
falling threshold value.
None
Falling Threshold
Specify the falling threshold for the sampled statistic. If the configured
threshold value is reached, an alarm is raised. If the current sampled
value is less than or equal to this threshold, and the value at the last
sampling interval was greater than this threshold, a single event is
generated. Enter a value between 0 and 2147483647.
Note:
The falling threshold value needs to be less than the rising
threshold value.
None
Rising Event Index
Specify the index of the event that needs to be raised when a rising
threshold is crossed. Enter the value between 1 and 65535 that
corresponds to the index value of an entry in the RMON Event
Configuration table. If there is no corresponding entry in the RMON
Event Configuration table, no association can exist.
None
Falling Event Index
Specify the index of the event that needs to be raised when a falling
threshold is crossed. Enter the value between 1 and 65535 that
corresponds to the index value of an entry in the RMON Event
Configuration table. If there is no corresponding entry in the RMON
Event Configuration table, no association can exist.
None
Owner
Specify the owner of the entry by entering a name. None