DVS Series Managed Industrial Ethernet Switches User’s Manual
LAG Settings
Description Factory Default
Port
This field shows the interface number.
interface number
Link Status
This filed show the connection of the interface.
Link Up: The interface is connected to another device.
Link Down: The interface is not connected to another device.
Link Down
Admin Mode
Specify the administrative state of the interface:
Enable: The interface is switched on and can be connected to
another device.
Disable: The interface is switched off and cannot be connected to
another device.
Enable
Jumbo Frame
The filed displays whether jumbo frame is enabled for the port.
Enable: Jumbo frame is enabled. The switch supports a fixed jumbo
frame size - 9000 bytes payload (9018 bytes frame) size.
Disable: Jumbo frame is disabled.
Disable
Link Trap
Specify whether the switch sends a trap when the interface link status
changes:
Enable: When the link status changes, the switch sends a trap. This
is the default setting.
Disable: When the link status changes, the switch doesn’t send a
trap.
Enable
3.1.4 Time
The switch supports SNTP (Simple Network Time Protocol). It can work as an SNTP client to get
time from an SNTP or NTP server, and it also can work as an SNTP server to provide time service
and send a time reply to a client.
3.1.4.1 SNTP Scalars Configuration
The SNTP Scalars Configuration lets a user to configure the time of the switch which gets from
SNTP server or not. And it also can be configured manually.
3-10
To Next Page
Loading...
Need help?
General
