4
Amplon N Series
1.2 Standard Compliance
z
CE
z
EN 62040-1
z
EN 62040-2 Category C2
1.3 Storage
z
Prior to installation
If the UPS needs to be stored prior to installation, it should be placed in a dry
area. The allowable storage temperature is between -15°C and +50°C.
z
After usage
Press the
OFF
button for 3 seconds and release it after you hear a beep, make
sure that the UPS has been completely shut down, disconnect the UPS from
the utility power, remove all loads from the UPS, and store the UPS in a dry and
well-ventilated area at a temperature between -15°C and +50°C. Idle batteries
must be recharged fully every three months if the UPS needs to be stored for
an extended period of time. When every time you charge the batteries, please
charge them until the Battery Level Bar Graph
shown on the UPS’s LCD is
fully on.
NOTE :
After storage and before start-up of the UPS, you must allow the UPS to
adjust to room temperature (20°C~25°C) for at least one hour to avoid
moisture condensing inside the UPS.
To Next Page
Loading...
Need help?
General