When “Small” has been selected for the surround speakers,
“Large” cannot be selected for the surround back speakers.
2 Parameters
Large:
Select this when using speakers that have sufficient ability to
reproduce bass sound below the frequency set for the
crossover frequency mode.
Yes / No:
Select “Ye s ” when a subwoofer is installed, “No” when a
subwoofer is not installed.
Small:
Select this when using speakers that do not have sufficient
ability to reproduce bass sound below the frequency set for the
crossover frequency mode. When this is set, bass sound with
a frequency below the frequency set for the crossover
frequency mode is sent to the subwoofer.
None:
Select this when no speakers are installed.
2sp / 1sp:
Set the number of speakers to be used for the surround back
channel.
If the subwoofer has sufficient low frequency playback
capacity, good sound can be achieved even when “Small” is
set for the front, center and surround speakers.
• Select “Large” or “Small” not according to the actual size of
the speaker but according to the speaker’s capacity for playing
low frequency (bass sound below the frequency set for the
Crossover Frequency) signals. If you are unsure, try comparing
the sound at both settings (setting the volume to a level low
enough so as not to damage the speakers) to determine the
proper setting.
Setting the Delay Time
Input the distance between the listening position and each
speaker to set the delay time for the surround playback.
Preparations:
Measure the distances between the listening position and the
speakers.
Center FRFL
Subwoofer
Listening position
SL SR
SBL SBR
1
Press the CURSOR
FF
or
GG
button to set the
distance from the front Lspeaker to the listening
position, then press the ENTER or CURSOR
HH
button to switch to the front R speaker setting.
2
Press the CURSOR
FF
or
GG
button to set the
distance from the front R speaker to the listening
position, then press the ENTER or CURSOR
HH
button to switch to the center speaker setting.
3
Press the CURSOR
FF
or
GG
button to set the
distance from the center speaker to the listening
position, then press the ENTER or CURSOR
HH
button to switch to the surround L speakers
setting.
4
Press the CURSOR
FF
or
GG
button to set the
distance from the surround L speakers to the
listening position, then press the ENTER or
CURSOR
HH
button to switch to the surround R
speaker setting.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
