EasyManuals Logo

Denon AVR-1803 User Manual

Denon AVR-1803
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
l Input the distance between the listening position and the different speakers to set the delay time for the surround mode
Preparations:
FL Center
FR
Measure the distances between the listenrng position and the speakers (Ll to L4 on the diagram at
the right).
Ll : Distance between center speaker and lrstening position
L2: Distance between front speakers/subwoofer and listening position
L3: Distance between surround speakers and listening position
L4: Distance between surround back speaker and listening position
CAUTION:
% Set the center speaker at the same distance from the front speakers (left and right) or the
subwoofer, or so that the difference in distance (L2 - Ll) IS 5 feet or less.
% Set the surround speakers (left and right) at the same distance from the front speakers (left and right)
or the subwoofer, or so that the difference in distance (L2 - L3) is 15 feet or less.
I Set the surround back speaker at the same drstance from the front speakers or the subwoofer, or
so that the difference in distance CL2 - L4) is 15 feet or less.
1
Use the 0 (left) and $) (right) buttons to set the distance from the front speakers and subwoofer to the
listening position.
j:-:i
~~,: : ..:.. ,.... : :
f.. i.y’i’.,i i : . . . . g:i ;
: . . : : : .’ . ...’ .::
:j, :;-; .i:’ ../::
l The number changes in units of 1 foot each time one of the buttons is pressed. Select the value closest l The number changes in units of 1 foot each time one of the buttons is pressed. Select the value closest
to the measured distance. to the measured distance.
(“/SW” appears only when subwoofer = yes.) (“/SW” appears only when subwoofer = yes.)
Press the ENTER or a (down) button to switch to the center speaker setting. Press the ENTER or a (down) button to switch to the center speaker setting.
NOTE:
l The speaker drstance can be adjusted between 0 and 60 feet in steps of 1 foot
Use the () (left) and () (right) buttons to set the distance from the center speaker to the listening position.
:...i
:.... I”” i, i ..~ ~ i”‘:
.: :-. . . . :
. . . .
f .y :..i : i:::-y
. . . . . . . . : :
: : .p “i”
.I. .::.. .
. . .
e The number changes in units of 1 foot each time one of the buttons is pressed. Select the value closest
to the measured distance.
Press the ENTER or a (down) button to switch to the surround speakers setting.
NOTE:
l No setting when “None” has been selected for the center speaker.
Use the 0 (left) and 0 fright) buttons to set the distance from the surround speakers to the listening
posrtion.
.: .-.
: : ,.:
:::y 1 ii;::: i:::: .: .-.
:. :
: : .Y
2.
.!. ::..: ....: :...: i . . . j .., :: .!. ::..:
i “i’:
* The number changes in units of 1 foot each time one of the buttons is pressed. Select the value closest
to the measured distance.
Press the ENTER or a (down) button to switch to the surround back speaker setting.
NOTE:
l No setting when “None” has been selected for the surround speakers
23

Other manuals for Denon AVR-1803

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-1803 and is the answer not in the manual?

Denon AVR-1803 Specifications

General IconGeneral
Channels6.1
Dolby DigitalYes
DTSYes
Dolby Pro Logic IIYes
Component Video SwitchingNo
Digital Inputs2 optical, 1 coaxial
TypeAV Receiver
Frequency Response10Hz-100kHz (+1, -3dB)
Signal to Noise Ratio100 dB
Input Impedance47 kOhms
Input Sensitivity200 mV
Built-in DecodersDolby Digital, DTS, Dolby Pro Logic II
Width17.1 inches
Tuner Frequency RangeFM: 87.5-108 MHz, AM: 522-1611 kHz
Power Output80 W per channel (8 ohms, 20Hz-20kHz, 0.08% THD)
Inputs5 A/V
Outputs1 digital optical
Total Harmonic Distortion0.08%
Audio D/A Converter24-bit/96kHz

Related product manuals