Denon AVR-1803 User Manual

DENON and other makes of components can be operated by setting the preset memory.
This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the
manufacturer of the component as shown on the List of Preset Codes (pages 126-‘I 30).
Operation is not possible for some models.
1
Set mode switch 1 to “AUDIO” or “VIDEO”.
AUDIO.
CD
.VIDEO-
AA
Set the AUDIO side for the CD, Tape deck or CDR/MD
position, to the VIDEO side for the DVD/VDP, DBSKABLE,
VCR or TV position.
2
Set mode switch 2 to the component to be registered.
""c"?? r'%,,E,
(CID
oVD'VDPiiiJ LD%ABLE
Ad
Press the ON/SOURCE button and the OFF button at the
3 sametime.q q
l Indicator flash.
4 000
Referring to the included List of
Preset Codes, use the number
buttons to input the preset code (a
@ @ @ ‘&digit
number) for the
O@@
Ob
manufacturer of the component
whose signals you want to store in
0
the memory.
5
To store the codes of another component in the memory,
repeat steps 1 to 4.
NOTES:
l The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operatron, cover the remote control
unit’s transmitting window while setting the preset memory.
l Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed on the
included list of preset codes.
l Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and
check.
l The preset memory can be set for one component only among the following: CDR/MD, DVDIVDP and DBSKABLE.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR.. ...................................................
HITACHI
CD, TAPE ..................................................
DENON
CDR/MD ...................................................
DENON (CDR)
DVD/VDP ..................................................
DENON (DVD)
DBS/CABLE ..............................................
ABC (CABLE)
28

Denon AVR-1803 Specifications

General

Channels	6.1
Dolby Digital	Yes
DTS	Yes
Dolby Pro Logic II	Yes
Component Video Switching	No
Digital Inputs	2 optical, 1 coaxial
Type	AV Receiver
Frequency Response	10Hz-100kHz (+1, -3dB)
Signal to Noise Ratio	100 dB
Input Impedance	47 kOhms
Input Sensitivity	200 mV
Built-in Decoders	Dolby Digital, DTS, Dolby Pro Logic II
Width	17.1 inches
Tuner Frequency Range	FM: 87.5-108 MHz, AM: 522-1611 kHz
Power Output	80 W per channel (8 ohms, 20Hz-20kHz, 0.08% THD)
Inputs	5 A/V
Outputs	1 digital optical
Total Harmonic Distortion	0.08%
Audio D/A Converter	24-bit/96kHz