I-I
-4
1
Set the input source to “TUNER”.
F”NCTlON
TUNER
0 s
(Mm unltj (Remote control unit)
2
Watching the display, press the BAND button to select the
desired band (AM or FM).
-2
3
Press the MODE button to set the auto tuning mode.
MODE
%
Ll!
IRemote control unItI
4
Press the TUNING
UP or
(Main unltl (Remote control unit)
l Automatic searching begins, then stops when a station is
tuned in.
NOTE:
l When in the auto tuning mode on the FM band, the “STEREO”
indicator lrghts on the display when a stereo broadcast is tuned in
At open frequencies, the noise is muted and the “TUNED” and
“STEREO” indrcators turn off.
1
Set the input function to “TUNER”.
3
Press the MODE button to set the manual tuning mode.
Check that the display’s “AUTO” Indicator turns off.
2
Watching the display, press the BAND button to select the
4
Press the TUNING UP or DOWN button to tune in the desired
desired band (AM or FM).
station.
The frequency changes continuously when the button is held
In.
NOTE:
l When the manual tuning mode is set, FM stereo broadcasts are recerved in monaural and the “STEREO” Indicator turns off.
To Next Page
Loading...
