Denon AVR-1803 User Manual

23
I-I
Preparations:
Use the “Auto tuning” or “Manual tuning” operation to tune in the
station to be preset in the memory.
1
;.;Y”“,t) Press the MEMoRY button.
I, I
t, 1
2
Press the SHIFT button and select the desired memory block
(A to E).
(Mm umti
Fkmote control umt)
NOTE: Please make sure the “AUDIO” position of the slide
switch on the remote control unit.
3
Press the PRESET UP or DOWN button to select the desired
preset channel (1 to 8).
4
MEMOKV
Press the MEMORY button again to
%
store the station in the preset
memory.
iRemote Control umt)
% To preset other channels, repeat steps 1 to 4.
A total of 40 broadcast stations can be preset - 8 stations
(channels 1 to 8) in each of blocks A to E.
1
Watching the display, press the SHIFT button to select the
preset memory block.
(Mm unltj mxnote control umtl
NOTE: Please make sure the “AUDIO” position of the slide
switch on the remote control unit.
2
Watchrng the display, press the PRESET UP or DOWN button
to select the desired preset channel.
(Main umt) (Remote control unit)
55

Denon AVR-1803 Specifications

General

Channels	6.1
Dolby Digital	Yes
DTS	Yes
Dolby Pro Logic II	Yes
Component Video Switching	No
Digital Inputs	2 optical, 1 coaxial
Type	AV Receiver
Frequency Response	10Hz-100kHz (+1, -3dB)
Signal to Noise Ratio	100 dB
Input Impedance	47 kOhms
Input Sensitivity	200 mV
Built-in Decoders	Dolby Digital, DTS, Dolby Pro Logic II
Width	17.1 inches
Tuner Frequency Range	FM: 87.5-108 MHz, AM: 522-1611 kHz
Power Output	80 W per channel (8 ohms, 20Hz-20kHz, 0.08% THD)
Inputs	5 A/V
Outputs	1 digital optical
Total Harmonic Distortion	0.08%
Audio D/A Converter	24-bit/96kHz