5. Protection Pass Mode
5.1. Actions
• This mode allows the power to be turned on without activating protections.
• This is the same as normal power-on, except that protections are not activated.
5.2. Operations
Hold down buttons "
TUNER PRESET CH -
", "
ZONE2 SOURCE
" and "
STATUS
" at the same time and press the power
button to turn on the power.
The device returns to the normal display after the following is displayed.
FLD
P r o t e c t i o n P a s s
This is displayed for 5 seconds before returning to the normal display.
6. CX870 / CY920 Reboot mode
6.1. Actions
• The CX870 / CY920 is restarted after CX870 / CY920 hangup.
• The CX870 / CY920 can be restarted even in the network standby setting ("
Setup menu
" – "
Network
" – "
Network
" –
"
Always On
").
6.2. Operations
1. Turn on the button "
MAIN ZONE
" and set NETWORK as the input source.
2. Hold down buttons "
TUNER PRESET CH +
" and "
TUNER PRESET CH -
" for at least 3 seconds while the power is on.
3. FL display during CX870 / CY920 reboot
FLD
N e t w o r k R e s t a r t
4. Returns to the normal display.
NOTE:
• The CX870 / CY920 Reboot operation is not accepted again for one minute after executing the reboot.
• Reception is prohibited during update, save and load.
65
To Next Page
Loading...
Need help?
General
Weight and Dimensions
