Denon AVR-X4000

154
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
2 Speaker Select
Makes settings for the speakers outputting sound.
Surround Back : Sound is output from the surround back speakers.
Height : Sound is output from the front height speakers.
Wide : Sound is output from the front wide speakers.
Back/Height : Sound is output from the surround back and front height
speakers.
Back/Wide : Sound is output from the surround back and front wide
speakers.
Height/Wide : Sound is output from the front height and front wide
speakers.
%
•This can be set when “Assign Mode” (vpage181) is set to “7.1ch (SB/FH/
FW)” or “9.1ch (SB/FH/FW)”.
•The speakers that can be selected by the “Main Pre-amps” setting are
changed when “Assign Mode” (vpage181) is set to “9.1ch (SB/FH/FW)”.
2 Set Defaults
The “Surround Parameter” settings are returned to the default settings.
Tone
Adjust the tonal quality of the sound.
2 Tone Control
Set the tone control function to “On” and “O”.
On : Allow tone adjustment (bass, treble).
O : Playback without tone adjustment.
2 Bass
Adjust bass.
–6dB – +6dB
2 Treble
Adjust treble.
–6dB – +6dB
%
•This cannot be set when the sound mode is set to “DIRECT” or “PURE
DIRECT”.