Denon AVR-X4000

156
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
2 Limit
Make a setting for maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB)
O (Default)
2 Power On Level
Define the volume setting that is active when the power is turned on.
Last (Default) : Use the memorized setting from the last session.
Mute : Always use the muting on condition when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
2 Mute Level
Set the amount of attenuation when muting is on.
Full (Default) : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
Audyssey
Set Audyssey MultEQ® XT32, Audyssey Dynamic EQ®, Audyssey Dynamic
Volume®, Audyssey LFC™ and Audyssey DSX®. These can be selected
after Audyssey® Setup has been performed. For additional information on
Audyssey technology, please see page241.
%
•“MultEQ® XT32”, “Dynamic EQ” and “Dynamic Volume” settings are stored for
each input source.
•“MultEQ® XT32”, “Dynamic EQ” and “Dynamic Volume” cannot be set when the
sound mode is set to “DIRECT” or “PURE DIRECT”.
2 MultEQ
®
XT32
MultEQ® XT32 compensates for both time and frequency characteristics
of the listening area based on Audyssey® Setup measurement results.
Selection is done from three types of compensation curves. We
recommend the “Audyssey” setting.
Audyssey (Default) : Optimize the frequency response of all speakers.
Audyssey Byp.L/R : Optimize frequency response of speakers except
front L and R speakers.
Audyssey Flat : Optimize frequency response of all speakers to flat
response.
Graphic EQ : Apply frequency response set with “Graphic EQ”
(vpage160).
O : Turn “MultEQ® XT32” equalizer o.
%
•When using headphones, “MultEQ® XT32” is automatically set to “O”.