Denon AVR-X4000

195
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
2 Mute Level
Set the amount of attenuation when muting is on.
Full (Default) : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
%
•This can be set when “Volume Level” is set to “Variable”.
Zone Rename
Change the display title of each zone to one you prefer.
MAIN ZONE / ZONE2 / ZONE3
Set Defaults : The input source name is returned to the default setting.
%
•Up to 10 characters can be input.
•For character input, see page148.
Quick Select Names
Change the “Quick Select” display title to one you prefer.
Quick Select 1 / Quick Select 2 / Quick Select 3 / Quick Select 4
Set Defaults : The input source name is returned to the default setting.
%
•Up to 16 characters can be input.
•For character input, see page148.
Trigger Out 1 / Trigger Out 2
Selects when to activate trigger out.
For details about how to connect the TRIGGER OUT jacks, see “TRIGGER
OUT jacks” (vpage52).
n When setting for zone (MAIN ZONE / ZONE2 / ZONE3)
Trigger out is activated through linkage to the power of the zone set
to “On”.
n When setting for input source
Activate trigger out when the input source set to “On” is selected.
n When setting for HDMI monitor
Activate trigger out when the HDMI monitor set to “On” is selected.
On : Activate trigger on this mode.
– – – : Do not activate trigger on this mode.