Denon AVR-X4000

183
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
2 Surr.Back
Set the presence, size and number of surround back speakers.
Large : Use a large speaker that can adequately play back very low
bass frequencies.
Small (Default) : Use a small speaker that has inadequate playback
capacity for very low bass frequencies. Note that this
is almost always the best choice.
None : Select when the surround back speakers are not connected.
2spkrs (Default) : Use two surround back speakers.
1spkr : Use only one surround back speaker. When you select this
setting, connect the surround back speaker to the left (L)
channel.
%
•When “Assign Mode” (vpage181) setting is “7.1ch (SB/FH/FW)”, “9.1ch
(SB/FH/FW)” or “7.1ch/2ch Front”, you can make the “Surr. Back” setting.
2 Subwoofer
Set the presence of a subwoofer.
2spkrs : Use two subwoofers.
1spkr (Default) : Use only one subwoofer.
None : Select when a subwoofer is not connected.
%
•When “Front” is set to “Small”, “Subwoofer” is automatically set to “1spkr”.
2 Surround
Set the presence and size of the surround speakers.
Large : Use a large speaker that can adequately play back very low
bass frequencies.
Small (Default) : Use a small speaker that has inadequate playback
capacity for very low bass frequencies. Note that this
is almost always the best choice.
None : Select when the surround speakers are not connected.
%
•When “Surround” is set to “None”, “Surr.Back”, “Front Height” and “Front
Wide” are automatically set to “None”.