16
ENGliSh
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control
[BUTTON]
Symbols used to indicate buttons in this manual
4
Press [MODE] to select the display mode.
The display mode switches each time [MODE] is pressed.
•There are two modes for displaying the contents recorded on the
iPod.
Browse mode
Display iPod information on the display of this unit.
Remote mode
Display iPod information on the iPod screen.
•“Remote iPod” is displayed on the display of this
unit.
Display mode
Browse mode Remote mode
Display location Main unit display iPod display
Playable
fi les
Audio fi le
P P
Video fi le
P
z
Active
buttons
Remote control
and main unit
P P
iPod
P
z Only audio is played back.
•The default display mode setting is “Remote mode”.
5
Use ui to select the item, then press [ENTER] or
<1/3
ENTER
> to select the music le to be played.
6
Press [1/3] or <1/3
ENTER
>.
Playback starts.
NOTE
•1st generation iPod nano and iPod video do not have remote mode
support.
•DENON will accept no responsibility whatsoever for any loss of iPod
data.
•Depending on the type of iPod and the software version, some
functions may not operate.
•This unit does not support playback on an iPad. Do not connect an
iPad to the unit.
•When connecting an iPhone to this unit, keep the iPhone at least 20
cm away from this unit. If the iPhone is kept closer to this unit and a
telephone call is received by the iPhone, noise may be output from
this device.
iPod
®
playback
You can use the USB cable provided with the iPod to connect the iPod
with the unit’s USB/iPod port and enjoy music stored on the iPod.
The unit can play back music stored on iPod/iPod touch/iPod classic/
iPod nano (the fi fth or later generation only).
n iPod
®
(vpage36)
Playing an iPod
1
Connect the iPod to the USB/iPod port using the
USB cable that was supplied with the iPod.
iPod
2
Press ON/STANDBY to turn on power to the main
unit.
3
Press [USB/iPod] to switch the input source to
“USB/iPod.
•For details on selecting the input source using the unit buttons, see
“Selecting the input source using unit operations” (vpage8).
[ENTER]
[HOME]
[MODE]
[DISPLAY]
[REPEAT]
[RANDOM]
[2]
[1/3]
[USB/iPod]
To Next Page
Loading...
