Denon DNP-720AE - Firmware Update; Add New Feature

28
ENGliSh
Add New Feature
•In order to add new functions, the environment and settings required
for connecting to broadband internet are needed (vpage6).
•Perform the add new feature operation after at least 2 minutes has
elapsed since turning this unit’s power on.
1
Press [MENU].
Turns on the Menu settings mode and the Menu appears on
the display (vpage20 “Menu map”).
2
Use ui to select “Other” – “Add New Feature”,
then press [ENTER], <1/3 ENTER > or p.
Start Upgrade
Execute the upgrade process.
•If the upgrade is not successful, an error message identical to those
in “Firmware Update”(vpage 28) will appear on the display.
Check the settings and network environment, then update again.
Upgrade Status
Display a list of the additional functions provided
by the upgrade.
Upgrade ID
The ID number shown on this screen is needed
when carrying out the procedure.
See the DENON website for details about updates.
When the procedure is complete, “Registered” is displayed and
updates can be carried out. If the procedure has not been carried
out, “Not Registered” is displayed.
[Notes concerning use of “Firmware Update” and
“Add New Feature”]
•Do not turn off the power until updating or upgrating is completed.
•Even with a broadband connection to the Internet, approximately
20 minutes is required for the updating/upgrading procedure to be
completed.
•Once updating/upgrade starts, normal operations on this unit cannot
be performed until updating/upgrading is completed.
•Furthermore, updating/upgrading the fi rmware may reset the backup
data for the parameters, etc. set for this unit.
•If the update or upgrade fails, remove and re-insert the power cord.
“UPDATE RETRY” appears on the display and update restarts from
the point at which update failed. If the error continues despite this,
check the network environment.
Setting the others [Other]
Firmware Update
•In order to update the fi rmware, the environment and settings
required for connecting to broadband internet are needed
(vpage6).
•Perform the fi rmware update operation after at least 2 minutes has
elapsed since turning this unit’s power ON.
1
Press [MENU].
Turns on the Menu settings mode and the Menu appears on
the display (vpage20 “Menu map”).
2
Use ui to select “Other” – “Firmware Update”,
then press [ENTER], <1/3 ENTER > or p.
Check for Update
Check for fi rmware updates. You can also check
approximately how long it will take to complete
an update.
Start
Execute the update process.
•If updating fails, the set automatically retries, but if updating is still
not possible, one of the messages shown below is displayed. If
the display reads as shown below, check the settings and network
environment, then update again.
Display Description
Updating fail Updating failed.
Login failed Failure to log into server.
Server is busy Server is busy. Wait a while then try again.
Connection fail Failure in connecting to server.
Download fail Downloading of the fi rmware has failed.
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control [BUTTON]
Symbols used to indicate buttons in this manual
[ENTER]
[DISPLAY]
[SEARCH]
[TUNER]
[MENU]
ui p
ui p
<1/3 ENTER>
1.DNP720AEE2_ENG_Final_0727.indd 28 2011/07/30 8:39:21