ENGLISH
Getting Started Setup Playback Setting the Timer Other Functions Troubleshooting SpecificationsSystem Functions
NOTE
• Do not plug in the power cord until all connections have been
completed.
• When making connections, also refer to the operating instructions of
the other components.
• Be sure to connect the left and right channels properly (left with left,
right with right).
• Do not bundle power cords together with connection cables. Doing
so can result in humming or noise.
Nail, tack, etc.
For details about system connections, also see “About
System Functions” (
v
page 22).
1
Put the stand section
through the bottom of the
loop antenna from the rear
and bend it forward.
2
Insert the projecting part
into the square hole in the
stand.
Loop antenna
Stand
Square
hole
Projecting
part
To use suspended on a
wall
Suspend directly on the wall
without assembling.
To use standing alone
Use the procedure below to
assemble.
NOTE
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• Do not connect two FM antennas simultaneously.
n Connecting the AM loop antenna
1
Push the lever.
2
Insert the conductor.
3
Return the lever.
AM loop
antenna
(supplied)
FM indoor antenna
(supplied)
Connections
Preparations
Assembling the AM loop antenna
Using the AM Loop Antenna
Antenna terminals
DAB (for UK Model Only)
DAB indoor antenna
(Supplied)
n Installing the DAB indoor antenna
DAB station reception (vpage 17).
AM/FM
The AM and FM reception sensitivity depends on the place the antenna
is set and the direction in which it is set. Set it so that reception is
best.
Connections
To Next Page
Loading...
