Denon DRA-F107 - System Functions; Auto Power on Function; Auto Function; Timer Function

ENGLISH

Getting Started Connections Setup Playback Setting the Timer Other Functions Specifications
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Symptom Cause Countermeasure Page
When the power
is turned on, the
power indicator
does not light
and no sound is
produced.
• Connection of the power cord is
faulty.
• Check that the power plugs are
securely inserted into the DRA-
F107’s AC inlet and the wall
power outlet.
10
The power
indicator lights
but no sound is
produced.
• The speaker cables are not
properly connected.
• The function is not switched to
the input source you want to
play.
• The volume is set too low.
• Connect securely.
• Switch to the correct function.
• Adjust the volume to an
appropriate level.
8
12
12
No sound is
produced from
one side.
• The speaker cables are not
properly connected.
• The input cables are not properly
connected.
• The left/right balance is off.
• Connect securely.
• Connect securely.
• Adjust the left/right balance.
8
9, 10
13
For stereo
sources, the
positions of the
instruments are
inverted.
• The connections of the speaker
cables or input cables are
inverted.
• Check and remedy the
connections.
8 ~ 10
GGeneralH
Symptom Cause Countermeasure Page
When playing
records, a wailing
noise (howling) is
produced when
the volume is
raised.
• The player and speakers are too
close together.
• The floor is soft and vibrates
easily.
• Move the player and speakers as
far apart as possible.
• Use cushions or spikes to absorb
the vibrations of the speakers
being conveyed from the floor.
–
–
GRecord PlayerH
Troubleshooting
USB/iPod 1/3
CD 1/3
System Functions
When the CD
1
/
3
or USB/iPod
1
/
3 button on the
remote control unit is pressed, the power of the respective
devices turns on and the DRA-F107’s function switches
automatically.
• CD
1
/
3
··································· When a disc is loaded, playback
starts.
• USB/iPod
1
/
3
························ The device connected to the USB
port is played.
NOTE
The auto power function does not work by pressing the play button on
the front panel of the DCD-F107 (CD player, sold separately).
Auto Power On Function
Auto Function
Timer Function
When the CD
1
/
3
or USB/iPod
1
/
3 button on the remote
control unit is pressed, the DRA-F107’s function switches
automatically and playback starts.
The currently playing source stops.•
Playback can be performed at a set time using the DCD-
F107
’
s timer function.
See “Timer Playback” (vpage 20) for details.•
System Functions Troubleshooting
See overleaf