Denon DRA-F107 - Cables Used for Connections; Speaker Connections; Connecting the Speaker Cables


Getting Started Setup Playback Setting the Timer Other Functions Troubleshooting SpecificationsSystem Functions
ENGLISH
w qw q
(R)(L)
Speakers
Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to the DRA-F107,
and be sure to interconnect the channels and polarities correctly.
1
Peel off about 10 mm of sheathing from
the tip of the speaker cable, then either
twist the core wire tightly or terminate
it.
2
Turn the speaker terminal counterclockwise
to loosen it.
3
Insert the speaker cable’s core wire to
the hilt into the speaker terminal.
4
Turn the speaker terminal clockwise to
tighten it.
NOTE
• Use speakers with an impedance of 4 to 16 Ω/ohms. The protection
circuit may be activated if speakers with an impedance other than
specified are used.
• Connect the speaker cables in such a way that they do not stick out
of the speaker terminals. The protection circuit may be activated if
the core wires touch the rear panel or if the + and – sides touch each
other (v “Protection circuit”).
• Never touch the speaker terminals while the power supply is
connected. Doing so could result in electric shock.
Protection circuit
The protection circuit will be activated in the following cases:
• When the speaker cable’s core wires are touching the rear panel or screws or when the speaker cable’s + and – sides are touching
• When the surrounding temperature is extremely high
• When the internal temperature rises due to extended use with a high output
When the protection circuit is activated, the speaker output is cut off and the power indicator flashes orange. If this happens, unplug the
power cord, then check the connections of the speaker cables and input cables. If the set’s temperature is extremely high, wait for it to cool
off and improve surrounding ventilation. After doing this, plug the power cord back in.
If the protection circuit is activated though there are no problems in ventilation around the set or in connections, the set could be damaged.
Turn off the power, then contact a DENON servicing and inquiry outlet.
When using an SC-F107 (speaker system, sold separately), we
recommend using the receiver's optimizing filter.
Signals adjusted for the SC-F107's properties are output.
(
v
page 22 “ Convenient Functions”).
Speaker Connections
Connecting the Speaker Cables
Preparations
Audio cables
Analog connections (stereo)
(White)
(Red)
R
L
R
L
Stereo pin-plug cable
Analog connections (for subwoofer)
Pin-plug cable
Analog connections (for portable player)
Stereo mini-plug cable
System connections
System cable (included with the system device)
Speaker connections
Speaker cables
Select the cables according to the equipment being connected.
Cables Used for Connections
Connections