38
Playing Tracks
To play or pause a track loaded to a deck, press Play/Pause.
To switch between Single and Continuous play, press Single/Cont on the desired deck.
When the button is lit, the deck is in Continuous Play Mode; after a track ends, the next track
in the track list will start playing. Continuous Play Mode will last for 60 tracks. After that,
playback will stop.
When the button is unlit, the deck is in Single Play Mode; after a track ends, the deck will stop
and the audio playhead will return to the initial cue point.
To move quickly through the track, press and hold Shift and then move the platter.
To jump to a specific location in the track:
• If the track is stopped, touch the desired part of the Needle Drop strip.
• If the track is playing, place the palm of your hand on the platter or press and hold Shift.
While doing that, touch the desired part of the Needle Drop strip. (This feature is to
prevent the track from skipping to another location if you accidentally touch it.)
To zoom into the audio waveform, press Zoom In. This affects both decks.
To zoom out of the audio waveform, press and hold Shift and then press Zoom Out. This
affects both decks.
To enable or disable Load Lock, press and hold Shift and press Single/Cont / Load Lock.
When enabled, the deck will not load a track during playback (to prevent you from unintentionally
interrupting the current track).
When disabled, if you load a track as another track is playing on that deck, the currently
playing track will stop, and the new track will load.
To Next Page
