Denon RCD-M40

24
5.3. Error display
"
13
"
C D E X - X X
(
13
lit
/
XX-XX：error code)
Error Code Description
E1-00 Disc cannot be detected.
E1-01 Tracking offset adjustment not possible.
E1-02 Focus offset adjustment not possible.
E2-00 The focus servo was disabled during playback.
E2-01 The focus servo was disabled during searching.
E2-03 The focus servo was disabled during TOC reading.
E2-06 The focus servo was disabled during manual search.
E2-10 Subcode became unreadable during playback.
E2-11 Subcode became unreadable during searching.
E2-12 Subcode became unreadable during TOC reading.
E2-14 Subcode cannot be read while pausing.
E2-15 Subcode cannot be read during manual search.
E3-00 TOC could not be read within the specied time.
E3-01 PVD/SVD analysis was not be completed within the specied time.
E4-04 Search time out (The search was not completed within the specied time).
E4-05 Decoder bus error (Error in communications with CD decoder).
E5-00 Inner switch is not on.
E6-00 Inner switch is not off.
E9-00 A CD u-COM error occurred
E9-01 Error other than above.
【Heat run count at the time the error occurred】
(1) Press the "
+/
9
" button while the error code is displayed.
(2) The heat run count is displayed for 5 seconds before returning to the error code display.
"
13
"
C D X X X X
(
13
lit
/
XXXX: heat run repetition count at the time the error occurred)
【Track number and elapsed time of track at the time the error occurred】
(1) Press the "
8
/-
" button while the error code is displayed.
(2) The track number and elapsed time of the track at the time the error occurred are displayed for 5 seconds before
returning to the error code display.
"
13
"
C D 0 1 Tr 0 1 : 4 7
(
13
lit
/
mm:ss: elapsed time of track at the time the error occurred)