54
(7) Reading modes
Items Parameters Defaults Refer to:
Regular read mode √
Scanning modes
Data verification mode
Disable transmission/
Disable transmission
√
Enable bar code data transmission/
Disable transmission
Enable bar code data transmission/
Enable NG transmission
Verification result output in data
verification mode
(Report of match/mismatch status)
Enable OK transmission/
Enable NG transmission
1st character √
2nd character
3rd character
4th character
5th character
6th character
Verification start position in data
verification mode
7th character
1 character
2 characters
3 characters
4 characters
5 characters
6 characters
7 characters
Number of characters to be verified, starting
from the verification start position
Not specified √
Enable
Scan lock in data verification mode
Disable √
Section 8.1
(8) Notification of a reading failure
Items Parameters Defaults Refer to:
Enable CAN transmission √
Enable ERROR transmission
Notification of a reading failure that
occurred under software control
Disable transmission
Section 6.2
: Can be changed only with the configuration software.
To Next Page
Loading...
