Derby cycle Kalkhoff - 11 Replacing Components of the Fast Pedelec; Components that Can Only be Replaced with the same or Approved Parts; Components that Do Not Require a; Components that Do Not Require a Certificate of Approval

28 Original User Manual | Pedelec Impulse Speed 2.0
• Gear-shi components: Only if the largest gear
ratio is not modied.
• Seatpost
• Bell: Can be replaced with an equivalent high-
pitched bell.
• Rear-view mirror: Can be replaced with a dierent
type-approved rear-view mirror.
• Chain
• Headset
• Inner tube
• Hubs
11 Replacing components of the fast
Pedelec
As your S-Pedelec is a Category L1e moped, it is neces-
sary to obtain a permit om the Federal Motor Transport
Authority and the technical inspection authority (TÜV),
as is the case with other motor vehicles in Germany. This
S-Pedelec has such a permit.
During the approval process, specic components were
dened as being suitable for use with this vehicle. This
means that the permit for your S-Pedelec only remains
valid if exactly the same approved components are used.
If components are modied or replaced, the same require-
ments apply as for other motor vehicles. You must only
use replacement parts that are certied as approved for
your S-Pedelec. Alternatively, you can have components
approved individually by the technical inspection author-
ity (TÜV).
The following lists show which components of your fast
Pedelec can be replaced and what rules apply.
11.1 Components that can only be
replaced with the same or approved
parts
• Frame
• Fork
• Motor unit
• Battery
• Tyres
• Wheel rims
• Brake system
• Front light
• Rear light
• Licence plate holder
• Side stand
• Handlebar
• Handlebar stem
11.2 Components that do not require a
certicate of approval
• Cranks
• Pedals: Providing type-approved pedal reectors
are used.
• Mudguard: The ont edge of the ont mudguard
must be rounded.
• Pannier rack
• Saddle
• Handlebar grips