Derby cycle Kalkhoff - Deleting All Data; Deleting Information on Variables; Display Range; Mode Button

14 User Manual | Pedelec with centre motor
DISPLAY POWER OUTPUT
6 bars more than 20 amperes (A)
5 bars up to 16–20 A
4 bars up to 12–16 A
3 bars up to 8- – 12 A
2 bars up to 2–8 A
1 bar up to 0–2 A
If the power consumption is very low, no bars
are displayed.
3.2.6 Mode button
Press the Mode button to display the following points in
the display panel consecutively. The setting that was se-
lected when you switched o is displayed rst.
• Trip
• Average speed
• Top speed
• Total journey length
• Remaining distance (only displayed in models om
2013): It displays the distance in km you can still
travel with power assist and depends on which
mode is currently selected. The higher the level of
assistance, the shorter the remaining distance.
If the battery is lly charged, the remaining distance
displayed is that possible under average conditions.
If the conditions of the journey change, for example,
by riding up an incline, the value displayed can also
decrease at short notice. Please consider this factor
when planning your trips. In time you will nd out
what distances you can travel given your riding style
and other conditions. You are probably familiar with
this eect om the remaining distance indicator of
your car.
3.2.6.1 Display range
DESCRIPTION DISPLAY RANGE
Speed 0.0–99.9km/h
Journey length 0.0–99999km
(Once the distance reaches
9999.9km, this is dis-
played without a decimal
place.)
Average speed 0–99.9km/h
Top speed 0.0–99.9km/h
Total journey length 0.0–99999km
(Once the distance reaches
9999.9km, this is dis-
played without a decimal
place.)
3.2.6.2 Deleting information on variables
If you keep the Mode button pressed for at least three
seconds with the control panel switched on, this resets
the “trip”, “average speed” and “top speed” readings to
zero. You cannot delete the “total journey length” using
this method.
3.2.6.3 Deleting all data
Press the Mode button to set all the data stored back to
zero. The display then automatically switches to the set-
tings section for “language”, “wheel circumference” and
“LCD contrast”.