Design Analysis H-522 - Default Chapter; Table of Contents

Table of Contents
User Agreement/WATERLOG Warranty.........................................
®
W-1
Chapter 1 Introduction
1.1 Introduction to the XL™ Series Data Logger. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1
1.2 Unpacking the XL™ Series Data Logger. ..................................... 1-2
1.3 Modes Of Operation. ..................................................... 1-3
1.3.1 SDI-12 Sensor Mode..................................................... 1-3
1.3.2 Data Logger / DCP Master Mode........................................... 1-3
1.3.3 Operation Using Auxiliary Outputs. ........................................ 1-4
1.3.4 Operation With The H-355 Gas Purge System (Bubbler). . . . . . . . . . . . . . . . . . . . . . . . 1-4
1.4 About this Manual........................................................ 1-4
1.5 Advanced Manual Sections................................................. 1-4
1.6 Web Page Support........................................................ 1-4
Chapter 2 Hardware Options and Installation
2.1 Mechanical Mounting. .................................................... 2-1
2.2 Front Panel Description.................................................... 2-1
2.2.1 Earth Ground Lug....................................................... 2-2
2.2.2 Pressure Reference Port (Vent)............................................. 2-2
2.2.3 Pressure Port (Input)..................................................... 2-2
2.2.4 GOES Antenna Output................................................... 2-3
2.2.5 GPS Antenna Connector.................................................. 2-3
2.2.3.1 Sample Installation for the Conoflow System. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4
2.2.3.2 Making the Pressure Connection to the H-355 Bubbler. . . . . . . . . . . . . . . . . . . . . . . . 2-5
2.2.6 Bubbler / Aux Port...................................................... 2-6
2.2.7 RS-232 Ports........................................................... 2-7
2.2.8 Analog Input Section. ................................................... 2-8
2.2.8.1 Analog Input Channels.................................................. 2-8
2.2.8.2 Analog Grounds....................................................... 2-8
2.2.8.3 Switched +5 Volt Reference Excitation.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-9
2.2.9 Wind Speed Input (AC Frequency Input). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-9
2.2.10 Event Counter Input................................................... 2-10
2.2.11 4 to 20 Milliamp Output................................................ 2-11
2.2.12 Digital I/O 1 and 2. ...................................................2–12
2.2.13 SDI-12 Section....................................................... 2-13
2.2.14 Power Connections.................................................... 2-14
2.3 Testing the Installation.................................................... 2-14
2.4 Hardware Revision Detection. ............................................. 2-15