Design Analysis H-522 - Page 5

Chapter 9 Scanning Options
9.1 Introduction............................................................. 9-1
9.2 Scanning Menus.......................................................... 9-1
9.3 Scanning Options......................................................... 9-1
Chapter 10 Stage Menus / Options
10.1 Stage Sensor and Remote Stage Setup....................................... 10-1
10.2 Stage / Temperature Menus (H-350XL Only). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-1
10.3 Stage Options (H-350XL / H-510XL Only). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-2
10.4 PtTemp Sensor Setup (H-350XL Only)...................................... 10-4
10.5 Remote Stage Setup Overview. ........................................... 10-5
10.6 Remote Stage Menus.................................................... 10-5
10.7 Remote Stage Options................................................... 10-5
Chapter 11 Analog Inputs / 5 Volt Excitation
11.1 Analog Inputs Overview. ................................................ 11-1
11.2 Analog Menus......................................................... 11-1
11.3 Analog Options. ....................................................... 11-2
11.4 Analog Input Connections................................................ 11-4
11.4.1 Analog Inputs and Analog Ground Connections. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-4
11.4.2 Switched +5.00 Volt Reference Excitation.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-5
11.5 Analog Input Setup Examples............................................. 11-6
11.6 Two Point Calibration Basics. ............................................ 11-7
Chapter 12 Digital I/O
12.1 Digital I/O Overview.................................................... 12-1
12.2 Digital I/O Menus. ..................................................... 12-1
12.3 Digital I/O Options...................................................... 12-2
12.4 Quadrature Shaft Encoder Options. ........................................ 12-7
Chapter 13 Counter And frequency Inputs
13.1 Introduction........................................................... 13-1
13.2 Counter and Frequency Menus. ........................................... 13-1
13.3 Counter Options........................................................ 13-2
13.4 Frequency Options...................................................... 13-6