Designability WizzyBug

Other manuals for Designability WizzyBug

User Instruction56 pages

Questions and Answers

M
mariegarciaSep 8, 2025
What to do if the seat is not properly fixed on my Designability Medical Equipment Wizzybug?
- S
  Sharon SpencerSep 8, 2025
  If the seat is not properly fixed into the Wizzybug body and/or the white dial cannot be locked on your Designability Medical Equipment, check that the front corners of the seat sit in both metal slots above the front of the battery compartment, and that the seat pins are sitting fully into the holes in the metal grid. You may also need to take out the seat completely and check that the seat backrest is fully located in a colour-coded slot on each side of the seat. If needed, reposition the backrest and re-try.
R
reidsharonSep 10, 2025
How to fix a Designability Wheelchair joystick that is not turning on?
- D
  Donald MartinSep 10, 2025
  First, ensure the main power switch at the rear of the Designability Wheelchair is turned on. If it still doesn't turn on, check that the battery is properly connected under the seat. If the battery is nickel metal hydride, remove it and press the 'Push to test' button. If it indicates zero power, reconnect it to the Wizzybug.
D
Danielle RuizSep 12, 2025
What to do if my Designability Wheelchair joystick controller is not working and displays a red flashing key?
- S
  Sarah WagnerSep 12, 2025
  If the joystick on your Designability Wheelchair is disabled and displaying a red flashing key, use the blue magnetic key (supplied with Wizzybug) and slide it over the number display to unlock the joystick.
K
Kristen McdowellSep 14, 2025
Why does my Designability Wheelchair joystick beep and turn off after turning on?
- G
  Gabriel AllenSep 14, 2025
  If the joystick of your Designability Wheelchair turns on, the lights scroll from right to left, and the joystick beeps and turns off (Shark Only), it means the joystick has been locked. Turn it on again and quickly press the horn button 3 times in succession to unlock it.
A
Anna PatelSep 16, 2025
What to do if the spanner light is flashing on my Designability Wheelchair joystick?
- V
  Victoria LopezSep 16, 2025
  If the spanner light is flashing on the joystick of your Designability Wheelchair, first turn the controller off and on again and recheck the joystick. If the spanner is still flashing, count the number of flashes in each sequence and ring Designability for assistance.
C
Christopher OlsenSep 18, 2025
Why is my Designability Wheelchair joystick controller not working with a green flashing key?
- E
  ericariceSep 18, 2025
  If the joystick controller of your Designability Wheelchair is not working and shows a green flashing key, and if speed setting 4 or 5 are selected, reset to 1, 2, or 3, as 4 and 5 are only available with the optional switches connected. If the speed settings are correct, count the number of flashes in each sequence and ring Designability for assistance.