- 44 - 6159924330 - 08/2020
Installing a Fieldbus module
Be aware that errors of manipulation can cause connection problems or a deterioration of electrical contacts.
We strongly recommend that a technician from Desoutter installs the modules.
Contact your Desoutter representative for support.
1. Power off the system.
2. Locate the Fieldbus connector on the bottom panel of the system. The connector is protected by a grey cover.
3. Remove the cover.
4. Carefully drive the Fieldbus module into its location.
5. Tighten the 2 screws by using a T9 Torx screwdriver.
6. Power on the system.
When the Fieldbus module is not present into its location, the cover must remain in place.
Refer to the user manual (printed matter: 6159931440) delivered in the packaging box or available at https://
www.desouttertools.com/resource-centre.
Installing external peripherals
Barcode readers, printers, Delta measuring units, etc... are external peripherals.
They can be connected to either RS232 or USB ports.
To Next Page
Loading...
Need help?
General
