6159924330 - 08/2020 - 29 -
A Connector 12 pts Male
B Connector 12 pts Female
a Ground shielded cable
b WARNING : Shielded insulate
STA Twisted pairs: 2x0.25 mm² at 10 MHz 65 Ω
STB
STA Red
STB Red / Blue
+15V Black / Blue
0V Black
Ground Yellow / Green
Phase 1 Black
Phase 2 Brown
Phase 3 Blue
Connecting CVI II tools range
It is required to mount an adaptor between CVI II tool cable and the CVI3 controller.
Refer to the user manual (printed matter: 6159922480) available at https://www.desouttertools.com/resource-centre.
Connecting ERS screwdrivers and ERP High Torque nutrunners
It is required to mount an adaptor between ERS and ERP High Torque tools and the CVI3 controller.
Refer to the user manual (printed matter: 6159921160) available at https://www.desouttertools.com/resource-centre.
Connecting cordless tools to CVI3 Vision
Ensure to have the last version of firmware and software for controllers and CVI CONFIG.
To get the last versions, go to https://www.desouttertools.com/resource-centre or contact your Desoutter repre-
sentative for support.
To install them, go to the chapter "Upgrade" in this manual.
There are 2 typical configurations:
• You have just received new Desoutter products (CVI3 Vision, cordless tool and WI-FI access point) and you
want to create a basic workstation. The only thing to do is to declare the cordless tool in the controller by creat-
ing a new tightening unit.
• You want to add one cordless tool in an existing installation or add a second cordless tool in your installation.
You will have to change the communication parameters of the cordless tool by using CVI MONITOR or the
easy-pairing feature.
Creating a basic workstation with a cordless tool
On delivery, Desoutter products (CVI3 Vision controller, cordless tool and WI-FI access point) are already pro-
grammed to communicate together.
The tool communicates with the controller via the WI-FI access point.
Example of installation with settings by default.
To Next Page
Loading...
Need help?
General
