8529-0637-2M Rev C DL Series Owner’s Manual
PRINTER, CONT.
Install Plain Paper
Different from the way in installing the gap paper shown. All you need to do is to put the paper
into the paper sensor and let the torn part be outside.
Operations Concerning Paper
PAPER TYPE
NOTE: The Paper Type key is only available on the DL1030P/DL1060P. The DL1030/1060
must change the paper type in Spec021. (0 = Plain Paper, 1 = Gap Paper).
Make sure the type of paper set is the same as the type of paper used. When the Gap Paper
annunciator on the display is turned on, you should change the setting to use gap paper.
Otherwise, you should use plain paper. Note that if the type of paper you set to use is different
from the type currently used, press and hold (for about 3 seconds) the Paper Type key to
change the setting.
FEED
After installing the paper, press the Feed key. You can also press the Feed key to clear issues
with the printer and to make the paper roll for a certain length.
Gap Paper Print Problems
NOTE: There are no gap adjustments required for using plain paper.
Problems may happen when the gap paper prints are abnormal, the paper goes out
continuously, or the printer won’t work after one label is printed.
• Check to make sure the paper is the right type.
• Referring to the previous section, INSTALL GAP LABELS, Step 6 – Perform Gap
Calibration, perform the Gap Calibration to eliminate the malfunction.
• When installing gap paper, make sure the edge of the gap paper does not exceed the
print head. (Do Not Block the Paper-Out Sensor!)
Paper-Out sensor
To Next Page
Loading...
Need help?
General
