Detecto DL1060 User Manual

8529-0637-2M Rev C  DL Series Owner’s Manual
33
ERROR CODES
Number Alarm Instructions Methods to Handle
E0.01
Weight is not stable when the
scale start-up
Make sure there are no goods on the tray and
the tray is stable
E0.02
Exceed the allowed start-up
zero range
Make sure there are no goods on the tray and
the tray is on the bracket
E1.01 Prog data is invalid Input valid data again
E1.03
The selected print format
does not exist
Set print format again
E1.10 Sale at 0 prices is forbidden
The sale whose sell price is 0 is forbidden
Refer to Spec070
E1.11 Exceed the largest sale price
The total price or grand total price of sold goods
exceeds the largest sale price
E1.12 Need to return to zero point
Return to weight zero before the sale
Refer to Spec069
E1.13 Exceed accumulative limit
The accumulative times are over the buffer
accumulate limit
E1.14
There is data in the buffer and
cannot print in single
Print the data in buffers first. Then print this sale
or switch to other buffers
E1.18
The system cannot execute
accumulative operations while
locking PLU
Before accumulative operations, the system
needs to exit lock PLU (or auto mode) first
E1.19
The system cannot switch
buffers into the buffer with
accumulation while locking
PLU
Operate in the current buffer, or exit lock PLU (or
auto mode)
E1.21
Less than smallest sale
weight
Weight needs to be larger than the smallest sale
weight
E1.22
Larger than the largest sale
weight
Weight needs to be smaller than the largest sale
weight
E1.23
Discounted Unit Price has to
be less than the discount
lower limit
Discounted in allowed range, or amend the
allowed range
E1.24
Discounted Unit Price has to
be higher than the discount
upper limit
E1.30
Cannot enter special sale
mode
Selected PLU has a conflict with special sale
mode, select again

Detecto DL1060 Specifications

General

Brand	Detecto
Model	DL1060
Category	Scales
Language	English