8529-0637-2M Rev C DL Series Owner’s Manual
OPERATION, CONT.
Batch Print Mode (only for Piece Count PLU)
NOTE: This operation requires the PLU to be programmed as a “2 = Piece Count” PLU.
Refer to Step:3 / Unit in the FAST PLU PROGRAMMING section.
1. With the scale in the normal operation mode, press the Batch Print key.
2. The scale will beep once, and the Auto Mode annunciator in the Tare window will turn on.
3. Use the numeric keys to enter the PLU number, and then press the PLU key.
4. The Unit Price annunciator in the Change/Unit Price window and the Single annunciator in
the Tare window will turn on.
5. Press the X (multiply key), and then use the numeric keys to enter the PLU quantity.
NOTE: If the PLU quantity is one (1), skip this step and proceed to step 6.
6. Press the Print key to confirm the PLU quantity.
7. Use the numeric keys to enter the number of labels desired, and then press the
Accu/Confirm key to confirm the number.
8. The number of labels entered will begin printing.
NOTE: To cancel once printing has started, press the Cancel key.
9. When the last label has been removed from the printer, the scale will exit the Batch Print
Mode, and the Auto Mode annunciator will turn off in the Tare window.
Pre-Pack Mode (only for weight PLU)
1. With the scale in the normal operation mode, press the Pre-Pack key.
2. The scale will beep once, and the Auto Mode and Lock PLU annunciators in the Tare
window will turn on.
3. Use the numeric keys to enter the PLU number, and then press the PLU key.
4. Place the items on the scale platform.
5. After the weight is stable, a label will automatically print.
6. Remove the item from the scale platform.
7. Repeat steps 4, 5, and 6 to print labels for the remainder of the items.
8. Press the Cancel key when finished printing the desired PLU labels.
9. Press the Pre-Pack key to exit the Pre-Pack Mode.
To Next Page
Loading...
Need help?
General
