EN - 54 SE-DV64-HE
CLEANING
2. Remove the dark outer
foam lter from the frame.
3. Wash the lter in a
solution of warm water and
dishwashing detergent, and
rinse with water.
4. Ensure the lter is
completely dry before
installation and use.
Filters
Air-Inlet Filter - Check every 10 days and clean as necessary.
CAUTION – Proper lter function is important for the operation of the
device and to protect the device from damage.
Tubing
Tubing should be cleaned daily.
1. Remove the tubing from the device and mask.
2. Use a mild detergent (e.g. Dawn
®
dishwashing liquid)
and warm water to clean the inside of the tubing. Rinse
the tubing and allow to air dry.
Carrying Case
1. Wipe with clean cloth
dampened with detergent or
disinfectant.
NOTE – If a reduced drying
time is desired, connect the
tubing to the CPAP device
and allow air to circulate
through the tubing until the
tubing is completely dry.
Inspect the tubing to ensure
that the tubing is completely
dry before use.
NOTE – Replace every 6
months.
Optional Fine Particle Filter -
Check every 10 days and replace
if dirty. CAUTION – Proper lter
function is important for the
operation of the device and to
protect the device from damage.
1. Replace every 30 days.
2. Install the ne particle lter
rst; then install the standard lter.
NOTE – If the ne particle lter is
not installed rst according to the
directions, the life of the lter will
be reduced requiring more
frequent replacement.
1. Remove lter cover.
5. Install lter cover on
back of device. NOTE–If
lter cover is missing,
device will operate
normally.
NOTE – If lter is
damaged, contact your
equipment provider for
replacement.
To Next Page
Loading...
