21 Initial use
devolo dLAN pro 1200+ WiFi ac/n
3.3 The dLAN pro 1200+ WiFi ac/n
The dLAN pro 1200+ WiFi ac/n is equipped with
쎲 An encryption button (home icon) with LED status
display,
쎲 A WiFi button with LED status display,
The LED status display and button
functionality can be deactivated on
the device's configuration interface
(see 4.3.4 System/Button/LEDs).
쎲 Two Ethernet ports,
쎲 One reset button
쎲 Four or two internal WiFi antennas and
쎲 One integrated electrical socket
3.3.1 Encryption button
This button controls the following functions:
Encrypting the dLAN pro network
쎲 To encrypt your dLAN pro network individually,
press each encryption button on the connected
devices for approximately 1 second—within 2
minutes.
쎲 To remove a dLAN pro device from your network,
press the encryption button on the correspond-
ing device for at least 10 seconds.
In the factory default settings, the
devices have unique passwords and
therefore do not connect to other
dLAN pro networks automatically.
For more information about this, refer to
Chapters 3.4 Connecting the
dLAN pro 1200+ WiFi ac/n or 3.6 Remove
dLAN pro 1200+ WiFi ac from the dLAN
pro network.
Indicator lights
The integrated indicator lights (LEDs) show the dLAN
status for the dLAN pro 1200+ WiFi ac/n by illuminat-
ing and/or flashing:
쎲 The LED flashes red quickly at regular intervals
if the dLAN pro 1200+ WiFi ac/n is connected to
the mains supply but there is no dLAN con-
nection.
Check whether the device is connected to the
mains supply correctly and whether the encryp-
tion process has been carried out successfully.
For more information about this, refer to 3.4
Connecting the dLAN pro 1200+ WiFi ac/n.
To Next Page
