23 Initial use
devolo dLAN pro 1200+ WiFi ac/n
쎲 In order to switch WiFi back on, tap the WiFi
button.
Indicator light
The integrated indicator light (LED) shows the WiFi
status for the dLAN pro 1200+ WiFi ac/n by illuminat-
ing and/or flashing:
쎲 When the WiFi connection is switched off, the
LED is also off.
쎲 When the WiFi connection is switched on, the
LED lights up white.
쎲 The LED lights up white if there is a connection to
the WiFi network.
You can find more information on this topic in
chapter 4.3.4 System/Button/LEDs.
3.3.3 Ethernet ports
The two network jacks can be used to connect comput-
ers or other network devices to the
dLAN pro 1200+ WiFi ac/n via commercially available
network cables.
3.3.4 Reset
The Reset button (on the side of the housing) has two
different functions:
쎲 The device restarts if you press the Reset button
for less than 10 seconds.
쎲 To change the configuration of the
dLAN pro 1200+ WiFi ac/n back to the factory
defaults, press the Reset button for more than
10 seconds. Keep in mind that all settings that
have already been configured will be lost!
You can use a pointed object (such as a paper
clip) to press the reset button.
3.3.5 WiFi antennas
The internal WiFi antennas are for connecting to other
network devices wirelessly.
3.3.6 Integrated electrical socket
If you connect additional devices using a power strip,
plug this power strip into the electrical socket of the
dLAN pro 1200+ WiFi ac/n. The integrated mains filter
eliminates any noise of connected devices and signifi-
cantly improves data transmission in the network.
3.4 Connecting the
dLAN pro 1200+ WiFi ac/n
The device may be used only indoors.
To Next Page
Loading...
