Initial use 26
devolo dLAN pro 1200+ WiFi ac/n
3.4.2 Starter Kit and Single Kit – Setting
up a new dLAN pro network
햲 Connect the dLAN pro 1200+ to your Internet
access device's network jack.
햳 Plug the dLAN pro 1200+ WiFi ac/n into a wall
socket. The device is ready to operate once the
indicator light of the encryption button with the
home icon turns white (after approximately 45
seconds).
To disconnect the device from the
mains supply, unplug the device. The
power socket and all connected net-
work devices should be easily acces-
sible so that you can pull the mains
plug quickly if needed.
Connecting the dLAN pro 1200+ and a
dLAN pro 1200+ WiFi ac/n as a dLAN pro network
Before you can use the device in a dLAN pro network,
first you have to connect it as a network. This is accom-
plished by using a shared dLAN password. This forms
a delimited dLAN pro network. Shared use of the dLAN
password serves as access control to the dLAN pro net-
work as well as the encryption, and thereby the inter-
ception protection, of the transmitted data.
The dLAN password can be set in different ways:
dLAN pro network encryption at the touch of a
button
햴 First press the encryption button (for about 1
second) of dLAN pro 1200+ and then, within
2 minutes, press the encryption button with the
home icon (for about 1 second) of
dLAN pro 1200+ WiFi ac/n.
햵 Your dLAN pro network is now set up and pro-
tected against unauthorised access.
or
dLAN pro network encryption using
dLAN AVpro manager computer software. More
information can be found in Chapter 3.5 dLAN
AVpro manager.
or
dLAN pro network encryption by entering the
dLAN password in the configuration interface.
More information can be found in Chapter 4 Network
configuration.
To Next Page
Loading...
