2 • Safety Information | Stelo Glucose Biosensor User Guide 5
Cautions
What to know before using the Stelo Glucose Biosensor System:
l
Read product instructions before you use the Stelo Glucose Biosensor System.
What to know before applying the sensor:
l
Don’t start a sensor past its Use By Date (YYYY MM DD) because it may give
incorrect results. You can start a new sensor on or before its Use By Date. This
gives you full wear.
l
Do not use any damaged or cracked Stelo Glucose Biosensor System components
because they may not work correctly and could cause injuries from electrical
shocks. If the applicator and/or sterile cap has been damaged or opened, it might
cause an infection. Don't remove cap until ready for insertion.
l
Clean and dry your hands prior to handling your sensor and clean your insertion
site with alcohol wipes to prevent infections. If your insertion site and hands aren't
clean and dry, you run the risk of infection and the sensor not sticking well. Before
insertion, don't apply insect repellent, sunscreen, perfume, or lotion on your
insertion site or sensor. This may cause the sensor to not stick well.
l
Only insert your sensor on the back of your upper arm. Don't wear your sensor on
other sites (such as your abdomen), as it may not work as expected.
l
The Stelo Glucose Biosensor System insertion safety guard is enabled until you
press the Stelo Glucose Biosensor System applicator down against your skin. Only
do this when ready to insert.
l
Change your insertion site with each sensor to allow the skin to heal. Avoid areas:
l
With loose skin or without enough fat to avoid muscles and bones.
l
That get bumped, pushed, or you lie on when sleeping.
l
Within 3 inches of an injection site.
l
With irritations, scarring, tattoos, or lots of hair. If needed, trim site with
electric clippers.
To Next Page
Loading...
