11 • Next Sensor Session | Stelo Glucose Biosensor User Guide 63
Remove your sensor
Before inserting a new sensor, remove the old one. You can use only one sensor at a
time with the Stelo Glucose Biosensor System. After your sensor session ends, peel
off the patch like a bandage. To make it easier and to avoid irritating your skin, try
these tips:
l
Loosen edge and soak patch in body oil, like baby oil or an adhesive remover for
skin (see product instructions before using)
l
Use adhesive removal wipes for skin, rubbing exposed skin as you peel back the
patch
l
Try different pulling techniques:
l
Pull off the patch slowly, folding it over itself, in the same direction of hair
growth
l
Stretch loosened edge, and push your fingers under the patch to pull it off skin
For more tips go to stelo.com/support.
Throw out the used sensor following local guidelines for blood-contacting
components.
To Next Page
Loading...
